Bondtech Drivegear kit 1.75/5.0
Bondtech drivegear kit in hardneded and surface protected steel.
Supersharp teeths for maximum grip on the filament.
The perfect choise for a high-performance feeding system.
Extremely high wear resistance for use with abrasive filaments.
Drivegear type: 1.75/5.0
These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.
Drivegear 1.75/5.0 kit content:
· primary gear with inner diameter 5 mm,
· secondary gear with two needle bearings,
· M3x2 setscrew
· 3 x 20 mm shaft.
A Lithium based grease is recommended to use on the gear section and inside the needle bearings for low friction and to avoid wear. A small dab of grease is enough.